Change V-USB config to allow for usbDeviceConnect in software

diff --git a/usbconfig.h b/usbconfig.h
index 92479bc732b92daa8fdfaa5be450d3f56b1d6b62..111fa236f2f19a7e78d0cd3eb81b50ca34d049b8 100644 (file)
--- a/usbconfig.h
+++ b/usbconfig.h
@@ -59,13 +59,13 @@ section at the end of this file).
 
 /* ----------------------- Optional Hardware Config ------------------------ */
 
-/* #define USB_CFG_PULLUP_IOPORTNAME   D */
+#define USB_CFG_PULLUP_IOPORTNAME   D
 /* If you connect the 1.5k pullup resistor from D- to a port pin instead of
  * V+, you can connect and disconnect the device from firmware by calling
  * the macros usbDeviceConnect() and usbDeviceDisconnect() (see usbdrv.h).
  * This constant defines the port on which the pullup resistor is connected.
  */
-/* #define USB_CFG_PULLUP_BIT          4 */
+#define USB_CFG_PULLUP_BIT          3
 /* This constant defines the bit number in USB_CFG_PULLUP_IOPORT (defined
  * above) where the 1.5k pullup resistor is connected. See description
  * above for details.
@@ -202,7 +202,7 @@ section at the end of this file).
 /* define this macro to 1 if you want the function usbMeasureFrameLength()
  * compiled in. This function can be used to calibrate the AVR's RC oscillator.
  */
-#define USB_USE_FAST_CRC                0
+#define USB_USE_FAST_CRC                1
 /* The assembler module has two implementations for the CRC algorithm. One is
  * faster, the other is smaller. This CRC routine is only used for transmitted
  * messages where timing is not critical. The faster routine needs 31 cycles